SIMOTICS M-1FE2 built-in motors
Hardware Installation Manual, 04/2020, A5E50074509B AA
3
Keeping the documentation safe
This documentation should be kept in a location where it can be easily accessed and made
available to the personnel responsible.
Target group
This Hardware Installation Manual addresses installation technicians, commissioning
engineers, service and maintenance personnel.
About this Hardware Installation Manual
This Hardware Installation Manual applies to the SIMOTICS M-1FE2 built-in motor, called
"1FE2" in the following text.
The Hardware Installation Manual explains how to handle the 1FE2 from delivery to disposal.
The Hardware Installation Manual provides information about the components that enable
the target group to install, set up, test, commission, operate, and troubleshoot the products
and systems correctly and safely.
● Before you start using the motor, you must read this Hardware Installation Manual. This
will ensure safe, problem-free operation and maximize the service life of the motor.
● Always follow the safety instructions and notices in this Hardware Installation Manual.
This Hardware Installation Manual complements the relevant Siemens Configuration Manual.
Siemens strives continually to improve the quality of information provided in this Hardware
Installation Manual.
● If you find any mistakes or would like to offer suggestions about how this document could
be improved, contact the Siemens Service Center.
The warning notice system is explained on the rear of the inside front.
To Next Page
Loading...
Need help?
General