Siemens SIMOTICS Series Hardware Installation Manual

Connection
7.2 Electrical connection
SIMOTICS M-1FE2 built-in motors
144 Hardware Installation Manual, 04/2020, A5E50074509B AA
7.2.7 Cable cross-section, cable outer diameter and cable variant for asynchronous
versions
The values specified in the following table refer to the cable outlet of the motor.
Cable cross-sections (Cu) and outer diameter of the connecting cables
Motor type
Cable length l
l = 0.5 m
1)
l = 1.5 m
2)
Cable cross-
section per
phase
in mm
2
Outer cable
diameter
in mm
Cable cross-
section per
phase
in mm
2
Outer cable
diameter
in mm
8-pole built-in motors
1FE2093-8AG☐☐-☐☐☐1
3 x 4
3.9
3 x 4
3.9
1FE2093-8AM☐☐-☐☐☐2
6 x 4
3.9
6 x 4
3.9
1FE2094-8AJ☐☐-☐☐☐1 3 x 4 3.9 3 x 4 3.9
1FE2094-8AM☐☐-☐☐☐2
6 x 4
3.9
6 x 4
3.9
1FE2094-8CJ☐☐-☐☐☐1
3 x 6
5
3 x 6
5
1FE2094-8CG☐☐-☐☐☐2
6 x 4
3.9
6 x 4
3.9
1FE2095-8CJ☐☐-☐☐☐1
3 x 6
5
3 x 6
5
1FE2095-8CG☐☐-☐☐☐2
6 x 6
5
6 x 6
5
1FE2145-8CE☐☐-☐☐☐1
3 x 10
6.2
3 x 10
6.2
1FE2145-8CC☐☐-☐☐☐2
6 x 6
5
6 x 6
5
1FE2147-8CE☐☐-☐☐☐1
3 x 2 x 10
6.2
3 x 2 x 10
6.2
1FE2147-8CC☐☐-☐☐☐2
6 x 10
6.2
6 x 10
6.2
1)
According to EN 46200 it can only be used in the motor spindle
2)
Notes on using cables are provided in VDE 0298, Part 3 and Part 4
You configure further connection cables appropriate for the rated current in accordance with
EN 60204-1 depending on the routing type and the ambient temperature.

Siemens SIMOTICS Series Specifications

General

Brand	Siemens
Model	SIMOTICS Series
Category	Engine
Language	English