Description
3.2 Overview of the motors
SIMOTICS M-1FE2 built-in motors
Hardware Installation Manual, 04/2020, A5E50074509B AA
23
3.2 Overview of the motors
The 1FE2 built-in motors are supplied as components.
You can select the following versions of the 1FE2 components.
Design without
cooling jacket
1 Rotor with externally mounted permanent magnets (APM)
2 Stator without cooling jacket
3 Installed 1FE2 built-in motor (shown without shaft)
1 Rotor with short-circuit cage
2 Stator without cooling jacket (Standard)
3 Installed 1FE2 built-in motor (shown
without shaft)
Design with
cooling jacket
1 Rotor with externally mounted permanent magnets (APM)
2 Stator with cooling jacket (optional)
3 Installed 1FE2 built-in motor (shown without shaft)
Frame sizes
16-pole 1FE218.-8L..
A complete motor is created after the rotor has been mounted into the stator.
As a rule, the built-in motor is installed in a motor spindle.
To Next Page
Loading...
Need help?
General