4 Mechanical Installation User Manual
Mount the Data Logger to the Wall
step 1 Mark positions for drilling holes on the installation wall. Drill the holes with a hammer drill of
φ6mm. (Note: Reserve sufficient clearances around the Data Logger.)
step 2
Insert the expansion sleeve into the drilled hole, and make it completely embedded in the wall
with a rubber hammer.
step 3
Insert the tap screw and mounting ear successively into the expansion sleeve, to fix the Data
Logger onto the wall.
step 4 Fasten the tapping screw with a screwdriver by the torque of 0.3N·m.
- - End
4.3.2 Rack-Mounted Installation
Use 1U standard rack in case of the rack-mounted installation.
Prerequisites
The following lists the components, tools, and devices used during installation.
16
To Next Page
Loading...
Need help?
General
