CHASSIS
3-84 LX Lawn Tractor Service Manual
3
Fig 323 PICT-7221
Before making a neutral adjustment, the transmission
must be warmed up for at least 10 minutes.
1. Loosen the bolt and washer retaining the right side
wheel to the right side axle (Fig. 323).
Neutral Adjustment - Hydrostatic
Models
Fig 325 PICT-7599
4. Locate the neutral adjusting puck and loosen the
Allen head bolt. If it’s diffi cult to loosen, heat the
aluminum housing near the bolt with a propane torch
(Fig. 325).
Fig 324 PICT-7597
2. Raise and support the right rear end of the tractor to
permit removing the right rear tire. Make sure the left
rear tire stays on the ground.
3. Remove the bolt, washer and wheel assembly from
the right axle (Fig. 324).
A. Adjusting puck
A
To Next Page
Loading...
Need help?
General
