• Connect all vacuum lines (i.e., EVAP, EGR system,
etc.)
• Make sure all MFI system wiring connectors are
fully connected
• Engine should be at normal operating tempera–
ture
• Switch off accessories
• Set transmission in neutral
(b) Connect a tachometer– to the engine
Connect the tachometer– test probe to the iG E) ter–
.rninal of the DLC1.
NOTICE:
• NEVER allow the tachometer terminal to touch
ground as it could result in damage to the igniter
and/or ignition coil.
• As some tachometers are not compatible with this
ignition system, we recommend that you confirm
the compatibility of your unit before use.
BRAKES
16. INSPECT BRAKE LINE PIPES AND HOSES
HINT: Inspect in a well – lighted area. Inspect the
entire circumference and length of the brake hoses
using a mirror as required. Turn the front wheels fully
right or left before inspecting the front brake.
(a) Check all brake lines and hoses for:
• Damage
(c) Race the engine at 2,500 rpm for approx. 2 minutes.
(d) Set the idle speed by turning the idle speed adjusting
screws.
Idle speed:
22R–E 4WD A/T 850 rpm
Ex. 4WD A/T 750 rpm
3VZ–E 800 rpm
(e) Remove the tachometer.
–MAINTENANCE MAINTENANCE OPERATIONS
MA–12
To Next Page
Loading...
Need help?
General
