Toyota 22R-E User Manual

(e) Select a new valve guide bushing.
If the valve guide bushing bore of the cylinder head is
more than 13.018 mm (0.512 in.), machine the bore to
the following dimension.
Rebored valve guide bushing bore dimension (cold):
13.050 – 13.068 mm (0.5138 – 0.5145 in.)
(d) Using a caliper gauge, measure the valve guide bus–
hing bore of the cylinder head.
10. IF NECESSARY, REPLACE VALVE GUIDE BUSH–
INGS
(a) Using a brass bar and hammer, break the valve –guide
bushing.
(c) Using SST and a hammer, drive out valve guide bus–
hing.
SST 09201–60011
(b) Gradually heat the cylinder head to approx. 90C
(194F).
13.000 – 13.018
(0.5118 – 0.5125)
Bushing bore mm (in.)
Bore intake and exhaust
Over 13.018
(0.5125)
Use O/S 0.05
Bushing size
Use STD
–ENGINE ENGINE MECHANICAL
EG1–24

Toyota 22R-E Specifications

General

Brand	Toyota
Model	22R-E
Category	Engine
Language	English