(b) When reusing precoated parts, clean off the old
adhesive and dry with compressed air. Then
apply the specified seal lock adhesive to the bolt,
nut or threads.
(c) Precoated parts are indicated in the component
illustrations by the ”*” symbol.
7. When necessary, use a sealer on gaskets to prevent
leaks.
8. Carefully observe all specifications for bolt tightening
torques. Always use a torque wrench.
9. Use of special service tools (SST) and special service
materials (SSM) may be required, depending on the
nature of the repair. Be sure to use SST and SSM
where specified and follow the proper work proce–
dure. A list of SST and SSM can be found in the
preparation part at the front of each section in this
manual.
10. When replacing fuses, be sure the new fuse has the
correct amperage rating. DO NOT exceed the rating or
use one with a lower rating.
MEDIUM CURRENT FUSE
HIGH CURRENT FUSE
CIRCUIT BREAKER
FUSIBLE L!1VK
Abbreviation
Illustration
Part Name
Symbol
M–FUSE
H–FUSE
FUSE
FUSE
–INTRODUCTION GENERAL REPAIR INSTRUCTIONS
IN–6
To Next Page
Loading...
Need help?
General
