8. INSTALL EGR VALVE
(a) Clean the set bolt (closest to the front) threads and
cylinder head bolt holes of any sealer, oil or foreign
particles.
Remove any oil with kerosene or gasoline.
(b) Apply sealant to 2 or 3 threads of the bolt end.
Sealant: Part No. 08833–00070, THREE BOND 1324 or
equivalent
• This adhesive will not harden while exposed to
air. It will act as a sealer or binding agent only
when applied to threads, etc. and air is cut off.
7. INSTALL EXHAUST MANIFOLD
(a) Position a new gasket on the cylinder head.
(b) Install the exhaust manifold with the eight nuts.
Torque the nuts.
Torque: 44N–m (450kgf–cm, 33ft–lbf)
6. INSTALL PLUG PATE
Install a new gasket and plug plate with the two bolts.
HINT: Attach the flat side of the gasket to the cylinder
head.
(c) Install the No. 2 exhaust manifold heat insulator with
the three bolts.
Torque: 19N–m (195kgf–cm, 14ft.–lbf)
–ENGINE ENGINE MECHANICAL
EG1–32
To Next Page
Loading...
Need help?
General
