(b) (M /T)
Install the flywheel on the crankshaft.
(c) (A/T)
Install the front spacer, drive plate and rear plate on
the crankshaft.
(d) Install and uniformly tighten the eight mounting bolts
in several passes, in the sequence shown.
Torque:
88 N–m (900 kgf–cm, 65 ft–lbf) for M/T
83 N–m (850 kgf–cm, 61 ft–lbf) for A/T
21. INSTALL FLYWHEEL OR DRIVE PLATE
(a) Apply adhesive to two or three threads of the mou–
nting bolt end.
Adhesive:
Pert No. 08833–00070, THREE BOND 1324
or equivalent
17. INSTALL CYLINDER HEADS
(See pages EG2–76 to 87)
18. INSTALL TIMING BELT
(See pages EG2–41 to 48)
19. REMOVE ENGINE STAND
20. INSTALL REAR END PLATE
Install the rear end plate with the bolt.
Torque: 7.4 N–m (75 kgf–cm, 65 in.–lbf)
–ENGINE ENGINE MECHANICAL
EG2–129
To Next Page
Loading...
Need help?
General
