9. INSTALL WATER PUMP PULLEY AND FLUID
COUPLING WITH FAN
(a) Temporarily install the water pump pulley and fluid
coupling with fan with the four nuts.
(b) Place the drive belt onto each pulley.
(c) Stretch the belt tight and tighten the four nuts.
10. ADJUST DRIVE BELT TENSION
(See page MA–6)
11. (with A/C) INSTALL A/C COMPRESSOR BRACKET,
COMPRESSOR AND BELT
(See page MA–6)
12. (w/PS) INSTALL PS BELT
(See page MA–6)
13. INSTALL OIL PAN
(a) Remove any old packing material and be careful not to
drop any oil on the contacting surfaces of the oil pan
and cylinder block.
8. INSTALL CRANKSHAFT PULLEY
(a) Install the crankshaft pulley and bolt.
(b) Using SST to hole the crankshaft pulley, torque the.
bolt.
SST 09213–70010 and 09660–00021
Torque: 157N–m(1,600kgf–cm, 116ft–lbf)
(c) (with A/C) Install the NO.2 crankshaft pulley.
6. INSTALL HEATER WATER OUTLET PIPE
Connect the heater water outlet pipe to the timing
chain cover with the two bolts.
7. INSTALL NO.1 WATER BY–PASS PIPE
Install the pipe with the two bolts.
–ENGINE ENGINE MECHANICAL
EG1–44
To Next Page
Loading...
Need help?
General
