3. REMOVE FLUID COUPLING WITH FAN AND
WATER PUMP PULLEY
(a) Loosen the water pump pulley set bolts.
(b) Loosen the belt adjusting bolt and pivot bolt of the
generator, and remove the drive belt.
(c) Remove the set nuts, fluid coupling with fan and
water pump pulley.
TIMING CHAIN REMOVAL
1. (W/PS)
REMOVE PS BELT
2. (with A/C)
REMOVE A/C BELT, COMPRESSOR AND BRACKET
4. REMOVE CRANKSHAFT PULLEY
(a) (with A/C (w/o Air pump) or w/PS (w/ Air pump))
Remove the No. 2 crankshaft pulley.
(b) Using SST to hold the crankshaft pulley, loosen the
pulley bolt.
SST 09213–70010 and 09330–00021
(c) Using SST, remove the crankshaft pulley.
SST 09213–310231
HINT: If the front seal is to be replaced, see page
EG1–236.
SST 09032 – 00100
HINT: When removing the oil pan, be careful not to
damage the oil pan flange.
–ENGINE ENGINE MECHANICAL
EG1–40
To Next Page
Loading...
Need help?
General
