To Next Page

To Previous Page

ASSEMBLY OF STARTER

(See page ST–2)

HINT: Use high–temperature grease to lubricate the bear–

ings and gears when assembling the starter.

1. PLACE ARMATURE INTO FIELD FRAME

Apply grease to the armature bearings and insert the ar–

mature into the field frame.

2. INSTALL BRUSH HOLDER

(a) Place the brush holder over the frame.

(b) Using a screwdriver, hold the brush spring back, and

connect the brush into the brush holder. Connect the

four brushes.

HINT: Check that the positive (+) lead wires are not

grounded.

Place the 0–ring on the field frame.

(d) Install the end cover to the field frame with the two

screws.

4. INSTALL GEARS AND CLUTCH ASSEMBLY

(a) Apply grease to the gears and clutch assembly.

(b) Place the clutch assembly, idler gear, bearing and pin–

ion gear 11.4, 1.6 kW) in the starter housing.

3. INSERT STEEL BALL INTO CLUTCH SHAFT HOLE

(a) Apply grease to the steel ball.

(b) Insert the steel ball into the clutch shaft hole.

–STARTING SYSTEM Starter

ST–9

Toyota 22R-E User Manual

Questions and Answers: