CYLINDER HEAD REMOVAL
1. REMOVE HEAD COVER
(a) Remove the ground strap from the body.
(b) Remove the four nuts and seals.
(c) Remove the head cover.
NOTICE: Cover the oil return hole in the head with a rag
to prevent objects from falling in.
2. REMOVE CAM SPROCKET BOLT
(a) Turn the crankshaft until the No. 1 cylinder position is
set at TDC compression.
(b) Place matchmarks on the sprocket and chain.
(c) Remove the half–circular plug.
21. (w/PS)
DISCONNECT PS BRACKET FROM CYLINDER
HEAD
Remove the four bolts, disconnect the ground strap
and bracket.
3. REMOVE DISTRIBUTOR DRIVE GEAR AND CAM–
SHAFT THRUST PLATE
(d) Remove the cam sprocket bolt.
–ENGINE ENGINE MECHANICAL
EG1–18
To Next Page
Loading...
Need help?
General
