5.
Unscrew and remove the oil filter using Triumph
service tool T3880312.
1.
Oil
Filter
2. Tool T3880312
6.
Discard the oil filter.
7.
Pre-fill a new oil filter with clean engine oil.
8.
Apply a smear of clean engine oil to the sealing
ring of the new oil filter.
9.
Fit the oil filter and tighten to
10
Nm.
10. After the oil has completely drained out, fit a new
sealing washer to the drain plug. Fit and tighten
the plug to
25
Nm.
11. Fill the engine with new oil of the type and grade
listed previously and in the specification section.
12. Start the engine and allow to idle.
A
Caution
,
I
Racing the engine before the oil reaches every part
I
I
can cause engine damage or seizure.
I
13. Ensure that the oil pressure warning light
extinguishes shortly after starting.
A
Caution
1
If the engine oil pressure is too low, the low oil
1
pressure warning light will illuminate. If this light
stays on when the engine is running, stop the
engine immediately and investigate the cause.
Running the engine with low oil pressure will cause
14. Stop the engine and check the oil level. Adjust if
Disposal
of
Used
Engine
Oil
(-
\
To protect the environment, do not pour oil on the
ground, down sewers or drains, or into water courses.
Dispose of used oil sensibly. If in doubt contact your
local authority.
I
Prolonged or repeated contact with engine oil can
I
lead
6
skin dryness, irritation and- dermatitis.
Furthermore, used engine oil contains potentially
harmful contaminants which can cause cancer.
When handling used engine oil, always wear
protective clothing and avoid any skin contact with
the oil.
A
Caution
Do not pour engine oil on the ground, down sewers
or drains, or into water courses. To prevent pollution
of water courses etc., dispose of used oil sensibly. If
in doubt contact your local authority.
necessary.
Sewice Manual
-
Speed Triple
To Next Page
Loading...
Need help?
General
