To Next Page

To Previous Page

151

MultiLine

There is no difference between multi-line calls and single-line calls when it

comes to recording calls. If recording has started, the call is recorded, otherwise

not. The recording status of a line continues as long as calls are connected to

this line.

For example, if line A is being recorded (initiated manually) and you switch to

line B or line A is placed on manual hold and you switch to line B, the recording

is ended and a partial recording saved.

If you disable recording for the call on line B (mode = manual or autostart) and

switch back to line A, the recording for line A is not started again.

The operating modes mentioned (All Calls, AutoStart or Manual) refer to the tele-

phone and are therefore the same for all lines.

Recording calls

Automatic call recording

This is the simplest mode. If you have accepted a call or called a subscriber and

the subscriber answers, the call is recorded automatically. Refer to

 page 150

to check which calls this can be.

As soon as the recording starts, you will see the recording symbol | and hear

a beep (see also

 page 150).

You cannot pause the recording manually in this mode.

Manual call recording

Activating or deactivating call recording when the telephone is in

idle mode.

Prerequisite: Manual mode is selected. The recording button is configured and

indicates the status.

Select the option shown in the telephone's context menu to enable the option

or disable the option.

Press the recording button to enable the option - the LED key lights up.

Or press the key shown to disable the option - the LED extinguishes.

Recording on

Recording off

Recording

Unify CP200 User Manual

Other manuals for Unify CP200