Unify CP200 User Manual

75
Held call wait status
After placing a call on hold, you can replace the handset and then decide wheth-
er to retrieve the call or disconnect.
Prerequisite: You placed a call on hold and replaced the handset or pressed
the loudspeaker key in speakerphone mode.
A recall follows immediately and a pop-up menu appears on the display:
Select and confirm the option shown to retrieve the call in speakerphone mode.
or
Select and confirm the option shown to disconnect the held call.
Activating and deactivating the hold reminder tone
z You can also configure this setting via the WEB interface  page 160.
@ Press the key shown.
Select and confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Retrieve held call ? l
Disconnect ? f
If you enabled Hold and hang-up" ( page 77), the call is placed on hold
for a defined time interval ( page 76) before the prompt is displayed with
a recall to retrieve the call or disconnect. You can however retrieve the call
or disconnect via the context menu before the defined time expires.
This function cannot be used on multi-line phones.
User
Configuration
Connected calls?
Allow hold rem. = No f
Yes l
Save & exit l

Unify CP200 Specifications

General

Brand	Unify
Model	CP200
Category	Telephone
Language	English