wc_tx003614gb_FM10.fm
154
Mobile Generator
General Maintenance
16.3 Preparing for Maintenance
Do not perform even routine service (oil/filter changes, cleaning, etc.) unless all
electrical components are shut down. Use the checklist below to prepare this
machine for maintenance.
Move the start switch to “OFF”.
Open the circuit breakers (move to the “OFF” position).
Close the emergency stop switch (push in).
Disconnect the negative terminal on the battery.
Attach a “DO NOT START” sign to the control panel.
If the unit is connected to a remote start or transfer switch, make sure the
remote switch is also off and tagged.
16.4 Cleaning the Machine
When
As needed
Suggested
cleaning
materials
■ Compressed air
■ Clean water supply
■ Mild detergent
■ Clean, dry cloths
NOTICE: Do not use a pressure washer to clean this machine. Pressurized water
can severely damage the generator and sensitive electronic components.
Cleaning the
interior
Clean the interior of the machine.
Check the fluid level in the containment skid (if equipped) and drain if necessary.
See “Checking / Draining the Containment Skid.”
Remove rags, containers, or other debris from the cabinet. Nothing should be
stored inside the machine.
Remove leaves and twigs from the exhaust compartment.
Wipe interior surfaces clean of oil, dust, and dirt.
Cleaning the
exterior
Clean the exterior of the machine with clean water and a mild detergent.
To Next Page
Loading...
Need help?
General
