Wacker Neuson G 25 User Manual

wc_tx003229gb_FM10.fm
88
Mobile Generator
Working with Basler Controller
8.14 Changing the Maintenance Interval
Requirements  Machine stopped
 Start switch in REMOTE START
Note: Internal programming of the genset controller, or closed connections to a
remote start switch, may cause the machine to start unexpectedly. Be prepared for
the engine to start even with the engine start switch in the REMOTE START
position.
Background The maintenance interval is the time, in hours, scheduled between critical
maintenance tasks (such as, changing the engine oil). The amount of time may be
changed if desired. The factory setting is 250.
Note: Refer to the Periodic Maintenance Schedule in the Operator’s Manual for
timing of all scheduled maintenance tasks.
Procedure Perform the procedure below to change the maintenance interval.
1. Press the right arrow button (1) to access the MAIN MENU.
2. Using the up/down arrow buttons (2, 3) highlight SETTINGS. Then, press the
right arrow button.
This procedure continues on the next page.

Wacker Neuson G 25 Specifications

General

Brand	Wacker Neuson
Model	G 25
Category	Portable Generator
Language	English