wc_tx003229gb_FM10.fm
75
Mobile Generator Working with Basler Controller
8.7 Changing the Time/Date Settings
Requirements
Machine stopped
Start switch in REMOTE START
Note: Internal programming of the genset controller, or closed connections to a
remote start switch, may cause the machine to start unexpectedly. Be prepared for
the engine to start even with the engine start switch in the REMOTE START
position.
Procedure
Perform the procedure below to change the time and date.
1. Press the right arrow button (1) to access the MAIN MENU.
2. Using the up/down arrow buttons (2, 3) highlight SETTINGS. Then, press the
right arrow button.
3. Highlight GENERAL SETTINGS. Then, press the right arrow button (1).
4. Highlight CONFIGURE DATE/TIME. Then, press the right arrow button.
5. Highlight the setting you want change. Then, press the check mark button (5).
6. If you are not logged in, enter the password “OP”. Press the check mark button.
7. Using the up/down arrow buttons, change the value as desired. Press the check
mark button when finished.
8. Exit by pressing the left arrow button (4) twice or until the LCD displays the
SETTINGS menu. Then, scroll to LOGOUT and press the check mark button.
Press the left arrow button so that the READY screen appears.
Result
The date/time settings have now been changed.
To Next Page
Loading...
Need help?
General
