wc_tx003579gb_FM10.fm
57
Mobile Generator
Operation (Basler Controller)
7.4 Overcurrent Condition
Along with engine functions, the genset controller continuously monitors the
current load in each leg. The values for current overload are programmed into the
ECM at the factory and are different for each generator size.
When an overcurrent condition is sensed in any leg, the pre-alarm/shutdown LED
(b) flashes and the LCD displays OVERCURRENT.
If the overcurrent condition persists, the main circuit breaker (a) opens and the
LCD screen changes to OVRLOAD - SET BRKR. This indicates an overload fault.
To clear the overload fault, reset the main circuit breaker. Failing to reset the main
circuit breaker within 5 minutes will cause the machine to shut down. The LCD
screen will then change to OVERLOAD.
A
Ø
HZ
V
R
Basler
DIAGNOSTICS
DIAGNOSEN
DIAGNOSTICOS
DIAGNOSTICS
wc_gr010360
a
b
To Next Page
Loading...
Need help?
General
