wc_tx003579gb_FM10.fm
64
Mobile Generator
Operation (Basler Controller)
7.9 Stopping the Machine
Check with other personnel on the jobsite and let them know that power is being
turned off. Make sure that the power shutdown will not create any hazards by
turning off devices such as pumps, heaters, or lights that may need to be kept on.
1. Turn off all loads connected to the generator.
2. Set the main circuit breaker to OFF.
3. Set the convenience receptacle circuit breakers to OFF.
4. Let the engine run for approximately five minutes to cool it down.
5. Move the engine start switch to the OFF position.
7.10 Emergency Stop Switch
Location
The emergency stop switch (a) is the red button located as shown, and can be
accessed with the panel doors closed.
Function
Activate the emergency stop switch by pushing the red button. Pushing the
emergency stop switch:
■ turns off (opens) the main circuit breaker
■ cuts power to the fuel solenoid
■ stops the engine
■ causes “Alarm Active: Emergency Stop” to appear on the LCD display
The emergency stop switch will remain activated until the button is pulled out.
NOTICE: Do not use the emergency stop switch to shut down the generator during
normal operation. The emergency stop switch is intended for use only in an actual
emergency situation where the generator must be stopped immediately.
To shut down the generator during normal operation, turn off (open) the main circuit
breaker and then move the engine start switch to the OFF position.
ALARM ACTIVEALARM ACTIVE
TO VIEWTO VIEW
EMERGENCY STOPEMERGENCY STOP
a
E
M
E
R
G
E
N
C
Y
wc_gr010365
To Next Page
Loading...
Need help?
General
