wc_tx003229gb_FM10.fm
71
Mobile Generator Working with Basler Controller
8.5 Logging in to the Genset Controller by Entering the Password
Precaution
Only change parameters when the READY screen is displayed (start switch in the
REMOTE START position).
Password
In order to change the parameters under the settings menu, you must be “logged
in” to the genset controller. There are two displays where you can log in to the
genset controller: 1) at the “ENTER PASSWORD” display under SETTINGS; or 2)
when prompted for the password by the genset controller at the parameter you
want to change.
The default password, in either case, is “OP”. It is set at the factory. It is the only
password available, and it cannot be changed.
Once you are logged in, you will remain logged in until:
you log out,
the machine is turned off,
or if you press the check mark button inadvertently. This usually happens when
attempting to change a locked parameter.
At ENTER
PASSWORD
To log in to the genset controller at the ENTER PASSWORD display, do the
following:
1. Press the right arrow button (1) to enter the main menu.
2. Use the up/down arrow buttons (2, 3) to highlight SETTINGS. Then, press the
right arrow button.
This procedure continues on the next page.
To Next Page
Loading...
Need help?
General
