Yaesu FT-100D - Spectrum Scope Operation

Spectrum Scope Operation
The SPECTRUM SCOPE allows viewing of operating activity on 15 channels above and 15
channels below the current operating channel. The SPECTRUM SCOPE is available in the
SSB/
AM/FM modes.
To activate the SPECTRUM SCOPE:
I. Press and hold in the [FUNC] key for I;i second to enter the MENU mode, then rotate the
SELECT knob to select MENU # 15 (SCOPE MONI).
2. Rotate the MAIN DIAL to select the desired sweep mode:
Cant: The
SPECTRUM SCOPE sweeps continuously.
Chec: The
SPECTRUM SCOPE sweeps one cycle every 30 seconds.
Sgl: The SPECTRUM SCOPE sweeps just once whenever you press the [FUNC]
key.
oFF: The SPECTRUM SCOPE is disabled.
3. Press the [FUNC] key momentarily to start the SPECTRUM SCOPE.
4. When the scope is in operation, the relative signal strength of stations on channels
immediately adjacent to the current frequency will be indicated on the display.
To disable the SPECTRUM SCOPE, select the "oFF" option in step 2 (above).
'~' , '" 0 In the FM and AM modes, the SPECTRUM SCOPE sweeps in increments
~ _ corresponding to the current VFO step. In the SSB mode, the SPECTRUM
/ '<:1 SCOPE utilizes 2.5 kHz steps.
o The receiver's audio output and S-meter are disabled when using the SPECTRUM
SCOPE.
76
FT-JOO ~[ICRO MOBILE OPERATING MANUAL