Technical data 153
Degree of protection
MicroFlex e150 complies with EN 60529, IP20 provided connector X1 is shrouded.
For UL purposes the MicroFlex e150 is defined as an open-type, single or three
phase, single axis servo amplifier.
The drive must be installed in a cabinet to fulfil the requirements for shielding from
contact. Access to the cabinet should be restricted to trained maintenance staff.
NOTE: The top surface of cabinets / enclosures which are accessible when the
equipment is energized shall meet at least the requirement of protective type IP3x
with regard to vertical access only.
Materials
CE marking
A CE mark is attached to the drive to verify that the unit follows the provisions of the
European, EMC, and machinery directives.
Compliance with the European EMC Directive
The EMC Directive defines the requirements for immunity and emissions of electrical
equipment used within the European Union. The EMC product standard EN 61800-3
covers requirements stated for drives. See section Compliance with the EN 61800-3
below.
Drive enclosure Side cover: PC+ABS-FR Bayblend FR3010 Black
Front Cover: PC/ABS GN-5001RFH Lupoy Light grey RAL9002
Heat sink: Die cast Aluminium LM6
Package Cardboard.
Disposal The drive contains raw materials that should be recycled to preserve
energy and natural resources. The package materials are
environmentally compatible and recyclable. All metal parts can be
recycled. The plastic parts can either be recycled or burned under
controlled circumstances, according to local regulations.
Most recyclable parts are marked with recycling marks.
The electrolytic DC capacitors and Integrated Power Module are
classified as hazardous waste within the EU and must be removed and
handled according to local regulations.
For further information on environmental aspects and more detailed
recycling instructions, please contact your local ABB distributor.
To Next Page
Loading...
Need help?
General
