ABB MicroFlex e150 User Manual

172 Accessories
 Feedback cables
The part number for a feedback cable is derived as follows:
These feedback cables have the outer shield tied to the connector housing(s). If you
are using an alternative cable with your chosen feedback device, be sure to obtain a
cable that is a shielded twisted pair 0.34 mm
2
(22 AWG) wire minimum, with an
overall shield. Ideally, the cable should not exceed 30.5 m (100 ft). Maximum wire-to-
wire or wire-to-shield capacitance is 50 pF per 300 mm (1 ft) length, to a maximum of
5000 pF for 30.5 m (100 ft).
 Ethernet cables
The cables listed in this table connect MicroFlex e150 to other Ethernet nodes such
as NextMove e100, additional MicroFlex e150s, or other Ethernet compatible
hardware. The cables are standard CAT5e shielded twisted pair (S/UTP) ‘crossover’
Ethernet cables:
Cable description Part Length
mft
CAT5e Ethernet cable CBL002CM-EXS
CBL005CM-EXS
CBL010CM-EXS
CBL020CM-EXS
CBL050CM-EXS
CBL100CM-EXS
CBL200CM-EXS
0.2
0.5
1.0
2.0
5.0
10.0
20.0
0.65
1.6
3.3
6.6
16.4
32.8
65.6
CBL 020 SF -E 1 S
RF
DF
WF
SF
D
B
E
S
A
1
-
2
S
-
m
ft
0.5
1.6
1.0
3.3
2.0
6.6
2.5
8.2
5.0
16.4
7.5
24.6
10
32.8
15
49.2
20
65.6
Raw cable Standard
connector
Stainless steel
connector
Incremental
encoder
EnDat
SinCos
BiSSBSM servo motor
feedback cable with at
least 1 connector
Raw cable
(no connector)
Other lengths available on request
Example:
A 2 m encoder feedback cable for a MicroFlex e150 drive, with required connectors at both ends, has part number
CBL020SF-E2.
Legacy
controllers
e100 / e150
SSI
Smart Abs
Servo motor feedback
cable with drive
connector only
SDM servo motor
feedback cable with at
least 1 connector

ABB MicroFlex e150 Specifications

General

Brand	ABB
Model	MicroFlex e150
Category	Control Unit
Language	English