Agilent Technologies 83620B User Manual

a semicolon. You must always end a program message with one
of the three program message terminators shown in Figure 1-29.
Use <new line> , <^END> ,or <new line> <^END> as the program
message terminator. The word <^END>> means that EOI is asserted
on the GPIB interface at the same time the preceding data byte
is sent. Most programming languages send these terminators
automatically.For example, if you use the HP BASIC OUTPUT
statement, <new line> is automatically sent after your last data
byte. If you are using a PC, you can usually congure the system to
send whatever terminator you sp ecify.
Subsystem Command Syntax
Figure 1-30 describes the basic syntax of SCPI subsystem commands.
Figure 1-30. Simplified Subsystem Command Syntax
As Figure 1-30 shows, there must be a <space> between the
last command mnemonic and the rst parameter in a subsystem
command. This is one of the few places in SCPI where
<space>
is required. Note that if you send more than one parameter with
a single command, you must separate adjacent parameters with a
comma. Parameter types are explained later in this subsection.
Common Command Syntax
Figure 1-31 describes the syntax of common commands.
Getting Started Programming 1-81

Agilent Technologies 83620B Specifications

General

Brand	Agilent Technologies
Model	83620B
Category	Inverter
Language	English