Agilent Technologies 83620B User Manual

NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Fltness Menu
When the ab ove command is set to atness CORR:SOUR FLAT , the
array chosen is the frequency-correction pair array. When the
command is set to array CORR:SOUR ARR , the arraychosen is the
1601 p oint correction set.
CORRection:SOURce[i]?
Queries the source of correction.
CORRection[:STATe] ON j OFF j 1 j 0
Sets the switch on the user atness correction feature. This is the
same as pressing 4
FLTNESS ON/OFF
5 on the front panel.
CORRection:STATe?
Queries the condition of the internal switch.
CORRection:FLATness:POINts? [MAXim um j MINimum]
The ab ove command returns information on how many
frequency-correction pairs were entered using the CORR:FLAT
command.
Analyzer: NONE
See Also
4
ALC
5 , 4
FLTNESS ON/OFF
5 ,
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
List Menu
\Optimizing Swept Signal Generator Performance" in Chapter 1
\Programming Typical Measurements" in Chapter 1
4
FLTNESS ON/OFF
5
Function Group
POWER
Menu Map
5
Description
This hardkey applies atness correction to the swept signal generator
RF output. If no array has b een created, pressing this k
ey applies
0 dB of atness correction at all p oin
ts. The yellow LED ab ove the
hardkey lights when user atness correction is on.
Programming Codes
SCPI: CORRection[:STATe] ON j OFF j 1 j 0
Analyzer: NONE
See Also
4
ALC
5 ,
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Fltness Menu
\Optimizing Swept Signal Generator Performance" in Chapter 1
F-10 Operating and Programming Reference

Agilent Technologies 83620B Specifications

General

Brand	Agilent Technologies
Model	83620B
Category	Inverter
Language	English