2
Operating and Programming Reference
HowTo Use This
Chapter
The operating and programming functions of the synthesizer are
listed in alphab etical order. Eachentry has a complete description,
complete programming co des, and a cross reference to the main
function group and resp ective menu map. Cross references to
operating and programming examples lo cated in Chapter 1, \Getting
Started", are also given.
Error messages, instrument specications, and menu maps are
lo cated in their own tabbed sections. Menu maps can b e folded out
and viewed at the same time as the alphab etical entry. See the
illustration b elow.
For operator's service information, see the Chapter 4, \Op erator's
Check and Routine Maintenance". The op erator accessible
4
SERVICE
5
softkeys are describ ed in that chapter. Complete
4
SERVICE
5
menu
and softkey information is provided in the
Agilent Technologies
8360 B-Series Swept Signal Generator/8360 L-Series Swept CW
Generator Service Guide
.
Programming Language
Comparison
Table 3-9 cross-references the actions that the instrument can
perform with the programming commands that will prompt those
actions.
Operating and Programming Reference 2-1
To Next Page
Loading...
Need help?
General
