aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Module Select Rear
Function Group
POWER and FREQUENCY
Menu Map
2 and 5
Description
This command causes the swept signal generator to examine only
the rear panel source mo dule interface connector to determine
the type of source mo dule (if any) connected. The instrument
frequency limits and multiplier are altered according to the source
mo dule connected. However, the leveling p ointis
not
changed. See
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Leveling Point Module
to set the swept signal generator to level
at the output of the source mo dule.
An asterisk next to the key lab el indicates this feature is active.
Programming Codes
SCPI:
SYSTem:MMHead:SELect FRONt
j
REAR
j
NONE
SYSTem:MMHead:SELect?
Analyzer:
NONE
See Also
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Module Menu
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Monitor Menu
Function Group
4
MOD
5
Menu Map
4
Description
This softkey (Option 002 only) accesses the men
u which allows you
to output internally-generated AM and FM waveforms to the rear
panel AM/FM OUTPUT connector. It also accesses the softkeys
which allo w you to display the AM depth and FM deviation of the
mo dulation waveforms.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
ModOut On/Off AM
Outputs the AM waveform to the AM/FM
OUTPUT connector.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
ModOut On/Off FM
Outputs the FM waveform to the AM/FM
OUTPUT connector.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Meter On/Off AM
Displays the AM depth of the mo dulating
signal.
M-26 Operating and Programming Reference
To Next Page
Loading...
Need help?
General
