Agilent Technologies 83620B User Manual

4
CW
5
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Coupling Factor
Function Group
ALC
Menu Map
1
Description
This softkey allows sp ecication of the coupling factor of an external
coupler/detector used to externally level the swept signal generator
output p ower. Negative coupling factor values are required for valid
entry. See \Sp ecications" for the coupling factor range.
Programming Codes
SCPI: POWer:ALC:CFACtor < num > [dB] j MAXimum j MINimum
Analyzer: NONE
See Also
4
ALC
5
\Externally Leveling the Swept Signal Generator" in Chapter 1
4
CW
5
Function Group
FREQUENCY
Menu Map
2
Description
This hardkey lets you select a synthesized continuous wave frequency.
When you press 4
CW
5 , the swept signal generator stops sweeping
(green SWEEP LED o ) and displays: --> CW: XXXXX MHz ,
where XXXXX represents a frequency value. Use either the rotary
knob, the step keys (with or without the left/righ t arrow keys), or
the numerical entry keys with a terminator key to set the desired
value. If a small change is desired, use the left and right arrow keys
to underline the digit to b e changed.
Programming Codes
SCPI:
FREQuency[:CW] < num > [freq sux] or
MAXimum j MINimum j UP j DOWN
FREQuency:MODE CW
Analyzer: CW
See Also
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
CW/CF Coupled , 4
START
5 , 4
STOP
5
\CW Operation and Start/Stop Frequency Sweep" in Chapter 1
\Programming Typical Measurements" in Chapter 1
Operating and Programming Reference C-13

Agilent Technologies 83620B Specifications

General

Brand	Agilent Technologies
Model	83620B
Category	Inverter
Language	English