SCPI COMMAND SUMMARY
PULM:SLEW:AUTO ON|OFF|1|0
PULM:SLEW:AUTO?
Sets and queries the automatic setting of rise time for the pulse
mo dulation system. The *RST setting is
ON
.
PULM:SOURce INTernal|EXTernal|SCALar
PULM:SOURce?
Sets and queries the source for the pulse mo dulation control signal.
*RST value is INTernal.
PULM:STATe ON|OFF|1|0
PULM:STATe?
Sets and queries the state of pulse mo dulation. The *RST value is 0.
ROSCillator:SOURce?
ROSCillator:SOURce INTernal|EXTernal|NONE
Sets and queries the reference oscillator selection switch. The
command to set the switch will cause ROSC:SOUR:AUTO OFF to
be done also. The *RST value is automatically determined.
ROSCillator:SOURce:AUTO ON|OFF|1|0
ROSCillator:SOURce:AUTO?
Sets and queries the automatic reference selection switch.
The *RST value is 1.
STATus:OPERation:CONDition?
Queries the Standard Op eration Condition register.
STATus:OPERation:ENABle <num>
STATus:OPERation:ENABle?
Sets and queries the Standard Operation Enable register.
The
STATus:PRESet
value is 0.
STATus:OPERation[:EVENt]?
Queries the Standard Op eration Event Register. This is a destructive
read.
STATus:OPERation:NTRansition <num>
STATus:OPERation:NTRansition?
Sets and queries the Standard Operation NegativeTransition Filter.
The
STATus:PRESet
value is 0.
STATus:OPERation:PTRansition <num>
STATus:OPERation:PTRansition?
Sets and queries the Standard Operation P
ositiveTransition Filter.
After STATus:PRESet, all used bits are set to 1s.
Operating and Programming Reference S-47
To Next Page
Loading...
Need help?
General
