When printing an enlarged/reduced image, select the method for enlargement/reduction. The image size sent to the
printer is displayed matching the selected method in Output Image Size.
The following settings are available for enlarged/reduced printing.
Setting Details
Fit Paper Size This automatically enlarges/reduces the entire image imported to Print Plug-In to
match the export media size when printing.
Fit Roll Paper Width This automatically enlarges/reduces the entire image imported to Print Plug-In to
match the width of the roll paper with the width of the image when printing.
*Displayed only if rolls are selected in Paper Source.
Scaling This enlarges/reduces the entire image by the specified scaling value. Input the scal-
ing value in numerical characters. You can specify a range between 5-600%.
*You can change the numbers by clicking either â–² or â–¼.
Note
• This is not displayed when a checkmark is placed in Borderless Printing.
•
Output Image Size
The output image size is displayed up to one place after the decimal point in millimeters.
Note
• When Paper Size is smaller than Output Image Size, part of the image may not print.
•
Paper Size
You can select the size of the print media.
Note
• This is not displayed when a checkmark is placed in Borderless Printing.
• This is not displayed when Fit Roll Paper Width is set in Enlarged/Reduced Printing.
•
Orientation
This selects the print orientation.
The following settings are available for orientation.
Setting Details
Portrait Prints the image on the media as it appears on the screen.
Landscape Prints the image on the media rotated 90 degrees.
•
Layout
You can select the print position of an image on the media.
The following settings are available for layout.
Layout
Setting
Details
Upper-Left of Output Paper
Size
Prints the image with fitting the top left of the active print area for Paper Size.
Mac OS X Software
>
Print Plug-In for Photoshop/Digital Photo Professional
>
iPF6300S Page Setup Sheet
4
623
To Next Page
Loading...
Need help?
General