Cisco 5510 - ASA SSL / IPsec VPN Edition User Manual

1-10
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring the ASA CSC Module
Configuring the CSC SSM
What to Do Next
See the “Diverting Traffic to the CSC SSM” section on page 1-10.
Diverting Traffic to the CSC SSM
You use Modular Policy Framework commands to configure the ASA to divert traffic to the CSC SSM.
Prerequisites
Before configuring the ASA to divert traffic to the CSC SSM, see Chapter 1, “Configuring a Service
Policy Using the Modular Policy Framework,” which introduces Modular Policy Framework concepts
and common commands.
To configure the ASA to divert traffic to the CSC SSM, perform the following steps:
Detailed Steps
Command Purpose
Step 1
access-list extended
Example:
hostname(config)# access-list extended
Creates an access list that matches the traffic you
want scanned by the CSC SSM. Create as many
ACEs as are needed to match all the traffic. For
example, to specify FTP, HTTP/HTTPS, POP3, and
SMTP traffic, you need four ACEs. For guidance on
identifying the traffic that you want to scan, see the
“Determining What Traffic to Scan” section on
page 1-3.
Step 2
class-map class_map_name
Example:
hostname(config)# class-map class_map_name
Creates a class map to identify the traffic that should
be diverted to the CSC SSM. The class_map_name
argument is the name of the traffic class. When you
enter the class-map command, the CLI enters class
map configuration mode.
Step 3
match access-list acl-name
Example:
hostname(config-cmap)# match access-list acl-name
Identifies the traffic to be scanned with the access list
that you created in Step 1. The acl-name argument is
the name of the access list.
Step 4
policy-map policy_map_name
Example:
hostname(config-cmap)# policy-map policy_map_name
Creates a policy map or modify an existing policy
map that you want to use to send traffic to the CSC
SSM. The policy_map_name argument is the name
of the policy map. When you enter the policy-map
command, the CLI enters policy map configuration
mode.
Step 5
class class_map_name
Example:
hostname(config-pmap)# class class_map_name
Specifies the class map, created in Step 2, that
identifies the traffic to be scanned. The
class_map_name argument is the name of the class
map that you created in Step 2. The CLI enters the
policy map class configuration mode.

Cisco 5510 - ASA SSL / IPsec VPN Edition Specifications

General

Brand	Cisco
Model	5510 - ASA SSL / IPsec VPN Edition
Category	Firewall
Language	English