Cisco 5510 - ASA SSL / IPsec VPN Edition User Manual

1-17
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Logging
Configuring Logging
Including the Device ID in Non-EMBLEM Format Syslog Messages
To include the device ID in non-EMBLEM format syslog messages, enter the following command:
Command Purpose
logging device-id {cluster-id |context-name |
hostname | ipaddress interface_name [system] |
string text}
Example:
hostname(config)# logging device-id hostname
hostname(config)# logging device-id context-name
Configures the ASA or ASASM to include a device ID in
non-EMBLEM-format syslog messages. You can specify only
one type of device ID for syslog messages.The context-name
keyword indicates that the name of the current context should
be used as the device ID (applies to multiple context mode
only). If you enable the logging device ID for the admin
context in multiple context mode, messages that originate in
the system execution space use a device ID of system, and
messages that originate in the admin context use the name of
the admin context as the device ID.
Note In an ASA cluster, always use the master unit IP
address for the selected interface.
The cluster-id keyword specifies the unique name in the boot
configuration of an individual ASA unit in the cluster as the
device ID. The hostname keyword specifies that the hostname
of the ASA should be used as the device ID. The ipaddress
interface_name keyword-argument pair specifies that the
interface IP address specified as interface_name should be
used as the device ID. If you use the ipaddress keyword, the
device ID becomes the specified ASA interface IP address,
regardless of the interface from which the syslog message is
sent. In the cluster environment, the system keyword dictates
that the device ID becomes the system IP address on the
interface. This keyword provides a single, consistent device
ID for all syslog messages that are sent from the device. The
string text keyword-argument pair specifies that the text string
should be used as the device ID. The string can include as
many as 16 characters.
You cannot use blank spaces or any of the following
characters:
• & (ampersand)
• ‘ (single quote)
• “ (double quote)
• < (less than)
• > (greater than)
• ? (question mark)
Note If enabled, the device ID does not appear in
EMBLEM-formatted syslog messages nor in SNMP
traps.

Cisco 5510 - ASA SSL / IPsec VPN Edition Specifications

General

Brand	Cisco
Model	5510 - ASA SSL / IPsec VPN Edition
Category	Firewall
Language	English