1-5
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring AnyConnect Host Scan
Installing and Enabling Host Scan on the ASA
Uninstalling Host Scan
Uninstalling Host Scan package removes it from view on the ASDM interface and prevents the ASA
from deploying it even if Host Scan or CSD is enabled. Uninstalling Host Scan does not delete the Host
Scan package from the flash drive.
Prerequisites
Log on to the ASA and enter global configuration mode. In global configuration mode, the ASA displays
this prompt: hostname(config)#.
Detailed Steps
Assigning AnyConnect Feature Modules to Group Policies
This procedure associates AnyConnect feature modules with a group policy. When VPN users connect
to the ASA, the ASA downloads and installs these AnyConnect feature modules to their endpoint
computer.
Command Purpose
show webvpn csd hostscan
Example:
hostname# show webvpn csd hostscan
Show the version of Host Scan enabled on the ASA.
Command Purpose
Step 1
webvpn
Example:
hostname(config)# webvpn
Enter webvpn configuration mode.
Step 2
no csd enable
Example:
ASAName(webvpn)#no csd enable
Disables the Host Scan image you want to uninstall.
Step 3
no csd hostscan image path
Example:
hostname(webvpn)#no csd hostscan image
disk0:/hostscan-3.6.0-k9.pkg
hostname(webvpn)#no csd hostscan image
disk0:/anyconnect-NGC-win-3.0.0327-k9.pkg
Specifies the path to the Host Scan image you want to
uninstall. A standalone Host Scan package or an
AnyConnect Secure Mobility Client package may have
been designated as the Host Scan package.
Step 4
write memory
Example:
hostname(webvpn)# write memory
Saves the running configuration to flash.
After successfully saving the new configuration to flash
memory, you receive the message [OK].
To Next Page
Loading...
Need help?
General
