Cisco 5510 - ASA SSL / IPsec VPN Edition User Manual

1-18
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Connection Profiles, Group Policies, and Users
Configuring Connection Profiles
hostname(config)# tunnel-group_tunnel-group-name general-attributes
hostname(config-tunnel-general)#
The prompt changes to indicate that you are now in config-general mode, in which you configure the
tunnel-group general attributes.
For example, for the connection profile named docs, enter the following command:
hostname(config)# tunnel-group_docs general-attributes
hostname(config-tunnel-general)#
Step 2 Specify the name of the accounting-server group, if any, to use:
hostname(config-tunnel-general)# accounting-server-group groupname
hostname(config-tunnel-general)#
For example, the following command specifies the use of the accounting-server group acctgserv1:
hostname(config-tunnel-general)# accounting-server-group acctgserv1
hostname(config-tunnel-general)#
Step 3 Specify the name of the default group policy:
hostname(config-tunnel-general)# default-group-policy policyname
hostname(config-tunnel-general)#
For example, the following command specifies that the name of the default group policy is MyPolicy:
hostname(config-tunnel-general)# default-group-policy MyPolicy
hostname(config-tunnel-general)#
Configuring LAN-to-LAN IPsec IKEv1 Attributes
To configure the IPsec IKEv1 attributes, perform the following steps:
Step 1 To configure the tunnel-group IPsec IKEv1 attributes, enter tunnel-group ipsec-attributes configuration
mode by entering the tunnel-group command with the IPsec-attributes keyword in either single or
multiple context mode.
hostname(config)# tunnel-group tunnel-group-name ipsec-attributes
hostname(config-tunnel-ipsec)#
For example, the following command enters config-ipsec mode so that you can configure the parameters
for the connection profile named TG1:
hostname(config)# tunnel-group TG1 ipsec-attributes
hostname(config-tunnel-ipsec)#
The prompt changes to indicate that you are now in tunnel-group ipsec-attributes configuration mode.
Step 2 Specify the preshared key to support IKEv1 connections based on preshared keys.
hostname(config-tunnel-ipsec)# ikev1 pre-shared-key key
hostname(config-tunnel-ipsec)#
For example, the following command specifies the preshared key XYZX to support IKEv1 connections
for an LAN-to-LAN connection profile:
hostname(config-tunnel-ipsec)# ikev1 pre-shared-key xyzx
hostname(config-tunnel-general)#

Cisco 5510 - ASA SSL / IPsec VPN Edition Specifications

General

Brand	Cisco
Model	5510 - ASA SSL / IPsec VPN Edition
Category	Firewall
Language	English