1-7
Cisco ASA Series CLI Configuration Guide
Chapter 1 Introduction to the Cisco ASA
New Features
New Features in ASA 9.0(1)/ASDM 7.0(1)
Released: October 29, 2012
Table 1-5 lists the new features for ASA Version 9.0(1)/ASDM Version 7.0(1).
Note Features added in 8.4(4.x), 8.4(5), and 8.4(6) are not included in 9.0(1) unless they are explicitly listed
in this table.
Improved Host Scan and
ASA Interoperability
Host Scan and the ASA use an improved process to transfer posture attributes from the client
to the ASA. This gives the ASA more time to establish a VPN connection with the client and
apply a dynamic access policy.
This feature is not available in 8.5(1), 8.6(1), 8.7(1), 9.0(1), or 9.1(1).
Monitoring Features
NAT-MIB
cnatAddrBindNumberOfEnt
ries and
cnatAddrBindSessionCount
OIDs to allow polling for
Xlate count.
Support was added for the NAT-MIB cnatAddrBindNumberOfEntries and
cnatAddrBindSessionCount OIDs to support xlate_count and max_xlate_count for SNMP.
This data is equivalent to the show xlate count command.
This feature is not available in 8.5(1), 8.6(1), 8.7(1), 9.0(1), or 9.1(1).
NSEL Flow-update events have been introduced to provide periodic byte counters for flow traffic.
You can change the time interval at which flow-update events are sent to the NetFlow collector.
You can filter to which collectors flow-update records will be sent.
This feature is not available in 8.5(1), 8.6(1), 8.7(1), 9.0(1), or 9.1(1).
Hardware Features
ASA 5585-X DC power
supply support
Support was added for the ASA 5585-X DC power supply.
This feature is not available in 8.5(1), 8.6(1), 8.7(1), 9.0(1), or 9.1(1).
Table 1-4 New Features for ASA Version 8.4(5) (continued)
Feature Description
To Next Page
Loading...
Need help?
General
