1-29
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring SNMP
Where to Go Next
Where to Go Next
To configure the syslog server, see Chapter 1, “Configuring Logging.”
Additional References
For additional information related to implementing SNMP, see the following sections:
• RFCs for SNMP Version 3, page 1-29
• MIBs, page 1-29
• Application Services and Third-Party Tools, page 1-31
RFCs for SNMP Version 3
MIBs
For a list of supported MIBs and traps for the ASA and ASASM by release, see the following URL:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
Not all OIDs in MIBs are supported. To obtain a list of the supported SNMP MIBs and OIDs for a
specific ASA or ASASM, enter the following command:
hostname(config)# show snmp-server oidlist
Note Although the oidlist keyword does not appear in the options list for the show snmp-server command
help, it is available. However, this command is for Cisco TAC use only. Contact the Cisco TAC before
using this command.
The following is sample output from the show snmp-server oidlist command:
hostname(config)# show snmp-server oidlist
[0] 1.3.6.1.2.1.1.1. sysDescr
[1] 1.3.6.1.2.1.1.2. sysObjectID
[2] 1.3.6.1.2.1.1.3. sysUpTime
[3] 1.3.6.1.2.1.1.4. sysContact
[4] 1.3.6.1.2.1.1.5. sysName
[5] 1.3.6.1.2.1.1.6. sysLocation
RFC Title
3410 Introduction and Applicability Statements for Internet Standard Management Framework
3411 An Architecture for Describing SNMP Management Frameworks
3412 Message Processing and Dispatching for the Simple Network Management Protocol (SNMP)
3413 Simple Network Management Protocol (SNMP) Applications
3414 User-based Security Model (USM) for Version 3 of the Simple Network Management Protocol (SNMP)
3826 The Advanced Encryption Standard (AES) Cipher Algorithm in the SNMP User-based Security Model
To Next Page
Loading...
Need help?
General
