Preface
Conventions
xiv
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 3, “Configuration,” describes the how to use the web-based management
system to configure the access point.
Chapter 4, “Security Setup,” describes how to set up and enable the access point’s
security features.
Chapter 5, “Network Management,” describes how to use the web-based
management system to browse to other devices on a wireless network.
Chapter 6, “Managing Firmware and Configurations,” describes how to update
the access point’s firmware and use the management system to distribute firmware
and configurations to other access points.
Chapter 7, “Management System Setup,” describes methods of managing the
access point other than through the access point management system.
Chapter 8, “Special Configurations,” describes how to set up the access point in
network roles other than as a root unit on a wired LAN, such as in repeater or Hot
Standby mode.
Chapter 9, “Diagnostics and Troubleshooting,” describes how to identify and
resolve some of the problems that might arise when you configure an access point
running this software release.
Appendix A, “Channels, Power Levels, and Antenna Gains,” lists the channels
supported by the world’s regulatory domains.
Appendix B, “Protocol Filter Lists,” lists the protocols you can select for filtering
on the management system’s Protocol Filters pages.
Conventions
This publication uses the following conventions to convey instructions and
information:
Command descriptions use these conventions:
• Commands and keywords are in boldface text.
Notes, tips, and cautions use the following conventions and symbols:
Note Means reader take note. Notes contain helpful suggestions or references to
materials not contained in this manual.
To Next Page
Loading...
Need help?
General
