7-3
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 7 Management System Setup
SNMP Setup
• System Name—The name of the access point. The name in this field is
reported to your SNMP's management station as the name of the device when
you use SNMP to communicate with the access point.
• System Location—Use this field to describe the physical location of the
access point, such as the building or room in which it is installed.
• System Contact—Use this field to name the system administrator responsible
for the access point.
• SNMP Trap Destination—The IP address of the SNMP management station.
If your network uses DNS, enter a host name that resolves into an IP address.
• SNMP Trap Community—The SNMP community name required by the trap
destination before it records traps sent by the access point.
The Browse Management Information Base (MIB) link at the bottom of the
SNMP Setup page leads to the Database Query page.
Using the Database Query Page
Use the Database Query page to to find and change the value of many access point
managed objects. Figure 7-2 shows the Database Query page.
Figure 7-2 Database Query Page
Follow this link path to reach the Database Query page:
1. On the Summary Status page, click Setup.
2. On the Setup page, click SNMP in the Services section of the page.
3. On the SNMP Setup page, click Browse Management Information Base
(MIB).
To Next Page
Loading...
Need help?
General
