Cisco AIR-AP1230B-A-K9 - Syst. 1230 Aironet WLAN AP User Manual

Chapter 2 Using the Management Interfaces
Using SNMP
2-10
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Using SNMP
You use an SNMP management application to configure the access point with
SNMP. Follow these steps to configure the access point with SNMP:
Step 1 Compile the MIB you need to use in your SNMP management application. MIBs
supported by the access point are listed in Supported MIBs.
Step 2 Use a web browser, a Telnet session, or the console interface to open the Express
Setup page in the access point management system.
Step 3 Enter an SNMP community name in the SNMP Admin. Community field and
click OK or Apply.
Step 4 Follow this link path to reach the SNMP Setup page:
a. On the Summary Status page, click Setup.
b. On the Setup page, click SNMP in the Services section of the page.
Use the SNMP Setup page to enter detailed SNMP settings, such as the SNMP
trap destination. See the “SNMP Setup” section on page 7-2 for details on the
SNMP Setup page.
Supported MIBs
The access point supports the following MIBs:
• Standard MIB-II (RFC1213-MIB.my)
Supported branches:
– system (1.3.6.1.2.1.1)
– interfaces (1.3.6.1.2.1.2)
– ip (1.3.6.1.2.1.4)
– tcp (1.3.6.1.2.1.6)
– udp (1.3.6.1.2.1.7)
– snmp (1.3.6.1.2.1.11)

Cisco AIR-AP1230B-A-K9 - Syst. 1230 Aironet WLAN AP Specifications

General

Brand	Cisco
Model	AIR-AP1230B-A-K9 - Syst. 1230 Aironet WLAN AP
Category	Wireless Access Point
Language	English