Cisco AIR-AP1230B-A-K9 - Syst. 1230 Aironet WLAN AP User Manual

2-5
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 2 Using the Management Interfaces
Using the Command-Line Interface
Figure 2-2 The Network Map Window
Click the name of a wireless device to open a new browser window displaying a
Station page listing the access point’s local information for that device. Click Go
beside the device name to open a new browser window displaying that device’s
home page, if available. Some devices, such as PC Card clients, might not have
home pages.
Click show clients to display all the wireless client devices on your network. The
client names appear under the access point or bridge with which they are
associated. If clients are displayed, click hide clients to display only non-client
devices.
Using the Command-Line Interface
You can use a command-line interface (CLI) to configure your access point
through a terminal emulation program or a Telnet session instead of through your
browser. This section provides instructions for Microsoft’s HyperTerminal and
for Telnet; other programs are similar.

Cisco AIR-AP1230B-A-K9 - Syst. 1230 Aironet WLAN AP Specifications

General

Brand	Cisco
Model	AIR-AP1230B-A-K9 - Syst. 1230 Aironet WLAN AP
Category	Wireless Access Point
Language	English