Chapter 3 Configuration
Server Setup
3-54
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Settings on the Name Server Setup Page
The Name Server Setup page contains the following settings:
• Domain Name System
• Default Domain
• Domain Name Servers
• Domain Suffix
Domain Name System
If your network uses a Domain Name System (DNS), select Enabled to direct the
access point to use the system. If your network does not use DNS, select
Disabled.
Default Domain
Enter the name of your network's IP domain in the entry field. Your entry might
look like this:
mycompany.com
The Current Domain line under the entry field lists the domain that is serving the
access point. The current domain might be different from the domain in the entry
field if, on the Boot Server Setup page, you have DHCP or BOOTP set as the
Configuration Server Protocol, but you selected No for the setting “Use previous
Configuration Server settings when no server responds?”
Domain Name Servers
Enter the IP addresses of up to three domain name servers on your network. The
Current lines to the right of the entry fields list the servers the access point is
currently using, which may be specified by the DHCP or BOOTP server.
Domain Suffix
In this entry field, enter the portion of the full domain name that you would like
omitted from access point displays. For example, in the domain
“mycompany.com” the full name of a computer might be
To Next Page
Loading...
Need help?
General
