Chapter 5 Network Management
Using the Association Table
5-8
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
• Uptime—Displays the cumulative time the device has been operating since
the last reset.
• Software Version—Displays the version level of Cisco software on the
device.
• Announcement Packets—Total number of Announcement packets since the
device was last reset.
Hops and Timing Information
The table at the bottom of the Station page lists information on the chain of
devices, if any, between the device and the wired LAN, on the monitoring timeout
for the device, and on the time of the most recent system activity.
• Hops to Infra.—The number of devices between this station and the network
infrastructure.
• Activity Timeout—Total time that can elapse after the access point’s last data
receipt before the access point presumes the client device has been turned off.
See the “Settings on the Association Table Advanced Page” section on
page 3-63 for information on setting timeouts for each device class.
• Communication Over Interface—The network port over which the access
point or bridge is communicating with the device.
• Echo Packets—The link test sequence number; it lists the total number of link
test packets sent to this station.
• Latest Activity—Elapsed time in hours, minutes, and seconds since the
station and the access point last communicated. All zeros means there is
current communication.
Performing Pings and Link Tests
Use the ping and link test buttons to perform pings and link tests on the device. If
the device is associated to the access point through which you reached the Station
page, the link test button and packet fields appear. If the device is not associated
with the access point, only the ping button and packet fields appear.
To Next Page
Loading...
Need help?
General
