Chapter 3 Configuration
Routing Setup
3-56
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
File Transfer Protocol
Use the pull-down menu to select FTP or TFTP (Trivial File Transfer Protocol).
TFTP is a relatively slow, low-security protocol that requires no username or
password.
Default File Server
Enter the IP address or DNS name of the file server where the access point should
look for FTP files.
FTP Directory
Enter the file server directory that contains the firmware image files.
FTP User Name
Enter the username assigned to your FTP server. You don’t need to enter a name
in this field if you select TFTP as the file transfer protocol.
FTP User Password
Enter the password associated with the file server’s username. You don’t need to
enter a password in this field if you select TFTP as the file transfer protocol.
Routing Setup
You use the Routing Setup page to configure the access point to communicate
with the IP network routing system. You use the page settings to specify the
default gateway and to build a list of installed network route settings. Figure 3-24
shows the Routing Setup page.
To Next Page
Loading...
Need help?
General
