Chapter 3 Configuration
Server Setup
3-44
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Note For most configurations, you should leave Default Multicast Address Filter set to
Allowed. If you intend to set it to Disallowed, add the broadcast MAC address
(ffffffffffff) to the list of allowed addresses on the Address Filters page before
changing the setting.
Note If you plan to discard traffic to all MAC addresses except those you specify (the
Disallowed setting), be sure to enter your own MAC address as allowed on the
Address Filters page.
Maximum Multicast Packets/Second
Use this setting to control the number of multicast packets that can pass through
the Ethernet port each second. If you enter 0, the access point passes an unlimited
number of multicast packets. If you enter a number other than 0, the device passes
only that number of multicast packets per second.
Server Setup
This section describes how to configure the server to support access point
features. You use separate management system pages to enter server settings. The
server setup pages are described in the following sections:
• Entering Time Server Settings, page 3-45
• Entering Boot Server Settings, page 3-47
• Entering Web Server Settings and Setting Up Access Point Help, page 3-50
• Entering Name Server Settings, page 3-53
• Entering FTP Settings, page 3-55
Note See the “Enabling EAP on the Access Point” section on page 4-19 for instructions
on setting up the authentication server.
To Next Page
Loading...
Need help?
General
