3-9
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 3 Configuration
Filter Setup
Follow this link path to reach the AP Radio Protocol Filters page:
1. On the Summary Status page, click Setup.
2. On the Setup page, click Filters in the AP Radio row under Network Ports.
The left side of the Protocol Filters page contains links to the Ethertype Filters,
the IP Protocol Filters, and the IP Port Filters pages. These links also appear on
the main Setup page under Associations. Use the Protocol Filters pages to assign
protocols to a filter set. Table B-1, Table B-2, and Table B-3 in Appendix B list
the protocols available on each page.
Creating a Protocol Filter
Follow these steps to create a protocol filter:
Step 1 Follow the link path to the Ethernet or AP Radio Protocol Filters page.
Step 2 Click Ethertype, IP Protocol, or IP Port to display the Filters page that contains
the protocols you want to filter. Figure 3-5 shows the Filters page.
Figure 3-5 Filters Page
Step 3
Enter a descriptive filter set name in the Set Name field.
Step 4 Enter an identification number in the Set ID entry field if you want to assign a
specific SNMP identifier to the filter set. If you don’t enter an ID, an SNMP
identifier will be assigned to the set automatically, starting with 1 for the first
filter set and incrementing by one for each additional set.
Step 5 Click Add New. The Filter Set page appears. Figure 3-6 shows the Filter Set page.
To Next Page
Loading...
Need help?
General
