Chapter 5 Network Management
Enabling Wireless Network Accounting
5-16
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Settings on the Port Assignments Page
• ifIndex—Lists the port’s designator in the Standard MIB-II
(RFC1213-MIB.my) interface index.
• dot1dBasePort—Lists the port’s designator in the Bridge MIB (RFC1493;
BRIDGE-MIB.my) interface index.
• AID—Lists the port’s 802.11 radio drivers association identifier.
• Station—Enter the MAC address of the device to which you want to assign
the port in the port’s Station entry field. When you click Apply or OK, the
port is reserved for that MAC address.
Enabling Wireless Network Accounting
You can enable accounting on the access point to send network accounting
information about wireless client devices to a RADIUS server on your network.
Cisco Secure ACS writes accounting records to a log file or to a database daily.
Consult the Cisco Secure ACS 2.6 for Windows 2000/NT Servers User Guide for
instructions on viewing and downloading the log or database:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacs4nt/csnt2
6/index.htm
If you have a UNIX server, use this URL to browse to the CiscoSecure ACS 2.3
for UNIX User Guide:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/cs_unx/csu23
ug/index.htm
Use the Accounting Setup page to enable and set up accounting on the access
point. Figure 5-8 shows the Accounting Setup page.
To Next Page
Loading...
Need help?
General
