Chapter 3 Configuration
Event Notification Setup
3-68
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
These selections affect display of events only. They are used to filter information,
not to remove it from the Event Log. To remove information from the Event Log,
click Purge Log on the Event Log page.
Event Handling Setup Page
You use the Event Handling Setup page to determine how notification of the fatal,
alert, warning, and information events should occur. You can choose to only count
the events, display them to the console but not store them, record them after
System warning
Protocol warning
Port warning
External warning
The Warning settings indicate that a failure has
occurred.
• System refers to the access point as a whole.
• Protocol refers to a specific communications
protocol in use, such as HTTP or IP.
• Port refers to the access point’s Ethernet or radio
network interface.
• External refers to a device on the network other
than the access point.
System information
Protocol information
Port information
External information
The Information settings indicate a normal action
that isn’t fatal (that is, the port has been turned off,
the rate setting has been changed, etc.)
• System refers to the access point as a whole.
• Protocol refers to a specific communications
protocol in use, such as HTTP or IP.
• Port refers to the access point’s Ethernet or radio
network interface.
• External refers to a device on the network other
than the access point.
Table 3-1 Event Display Severity Levels (continued)
Severity Level Description
To Next Page
Loading...
Need help?
General
